Note: This applies to DocuShare 6.5.x and 6.6.x.
Important! — Please Read
This article provides additional steps that you MUST follow after installing or upgrading DocuShare software. Read this article before installing or upgrading DocuShare software.
New DocuShare installations—After completing the DocuShare installation and site licensing using the instructions provided in the appropriate chapter of the DocuShare Installation Guide (available for download from https://docushare.xerox.com/doug), perform the procedure below.
DocuShare upgrades—After completing the DocuShare upgrade using the instructions provided in the appropriate chapter the DocuShare Installation Guide (available for download from https://docushare.xerox.com/doug), except for running dsindex index_all as you will run the command below, make sure the site is licensed and then perform the procedure below.
1. Stop DocuShare.
2. In a command prompt window, run \bin\idoltool -s resetserver all y.
Where is the installation directory for DocuShare. The default installation path is C:\Xerox\Docushare. Depending on your installation environment this path may vary.
Caution: The idoltool -s resetserver all y command clears the IDOL search indexes. This command only should be run immediately before running dsindex index_all.
3. Optional: To increase the allocation of available memory for IDOL on 64-bit Windows servers, run the appropriate idolsetup command according to the amount of RAM on the server.
· 4–8 GB RAM: \bin\idolsetup.bat idol_default.config
· 8–16 GB RAM: \bin\idolsetup.bat idol_medium.config
· 16–32 GB RAM: \bin\idolsetup.bat idol_large.config
· 32+ GB RAM: \bin\idolsetup.bat idol_unlimited.config
Note: At least 6 GB of RAM is recommended on a 64-bit Windows server.
4. Start DocuShare.
5. Run \bin\dsindex index_all.
6. Review the auto_recover_report.log file written to \bin directory.
Note: If there are no items to recover then the auto_recover_report.log will not exist.
7. Run \bin\verifyIndex.bat to verify that the documents in the repository have been
indexed.
8. If DocuShare was configured for LDAP, continue with the following steps. If your site does not use LDAP, you are finished with the procedure.
9. Log into DocuShare as admin and go to Admin Home.
10. From the Administration menu, click Account Management | LDAP Accounts | Bind Group.
11. On the Bind Group page, set the Keywords LDAP Attribute to cn. Click Apply.
12. On the same Bind Group page, remove the Keywords LDAP Attribute entry. Click Apply.
Note: These last two steps invoke a schema update to replace incorrect schema information with up-to-date attribute values from the LDAP server.
Solution Updated: January 27th, 2015
Solution ID: 640
Keywords:
Idolsetup
Resetserver
Medium
Large